This is a list of things that aren't quite right in Building Recreational Flight Simulators.
- Page 2, first line, "All right reserved." should be "All rights reserved."
- Page 31, 4th paragraph, 7th line: "...and your sim's just taken a set up in realism." should be "...and your sim's just taken a step up in realism."
- Page 43, figure 4, Some drawing line weights are too light.
- Page 53, figure 8, Some drawing line weights are too light.
- Page 60, figure 16, Some drawing line weights are too light.
- Page 61, figure 17, Some drawing line weights are too light.
- Page 74, 2nd paragraph, last line: "...9' by 12" bedroom" should be "...9' by 12' bedroom".
- Page 108, 2nd paragraph, 2nd line: "The two will fell different..." should be "The two will feel different..."
- Page 129, figure 7, Some drawing line weights are too light.
- Page 136, figure 12, The pivot hole in the throttle arm is incorrectly dimensioned as D5/8". It should be D3/8"
- Page 139, Bill of Materials, line item 19: "M2 x 1/4" machine screw" should be "M3 x 1/4" machine screw"
- Page 211, figure 18, There should be a 2.2 uFd cap from the MAX232 pin 16 to ground. The cap is shown on the overleaf parts placement diagram. No harm if you leave it out; it's just extra insurance against power supply noise. (Thanks for catching it, William.)
- Page 348, The Bill of Materials calls for DB9M and DB9F connectors. These should be DB15M and DB15F connectors.
- Page 440, 5th paragraph, 11th line: "The actually transmission..." should be "The actual transmission...".
- Page 471, 5th paragraph, 2nd line: "of the connected switches" should be "of the active and standby frequency variables".
- Page 587, foot note, URL format wrong, should be underlined.
- Page 593, figure 1, Some drawing line weights are too light.
- Page 595, 3rd paragraph, line 3: "improvements the DIY..." should be "improvements in the DIY..."